Onkyo TX-NR1000 instruction manual Using the Sleep Timer remote controller only

Connecting the Power/Basic Operations—Continued

Scroll wheel	MACRO									ZONE 2
	MODE									INPUT
	DIMMER									SLEEP	SLEEP
	TV		MENU				MEN		U
	INPUT	OP
		T			R	A	UDI
					VE
	+		ER				O	AD
			S
									J
	CH				ENTER					VOL
	DISC
	-			E				E
					XIT
							ID
	PREV					GU
		R							P
	CH	ET		URN				U
							SET
	DISPLAY									MUTING
	REC	MAIN A				MAIN B				RANDOM
	AUDIO	SUBTITLE				ANGLE				LAST M
	SURR		THX				ALL ST			STEREO
	REPEAT		A-B			SEARCH				MEMORY
CH SEL	PURE A		DIRECT				DSP			DSP	LEVEL–
	REPEAT		VIDEO				MUSIC			PHOTO
	TEST TONE		CH SEL				LEVEL-			LEVEL+	LEVEL+
	PLAYLIST	ALBUM				ARTIST				GENRE
		AUDIO SEL					L NIGHT			Re-EQ
	CAPS	DELETE				LANGUAGE				LOCATION

RC-557M

RC-558M

Using the Sleep Timer (remote controller only)

With the sleep timer you can set the TX-NR1000/ TX-NR5000E so that it automatically turns off after a set period.

Temporarily Changing the Speaker Output Levels (remote controller only)

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 and +12 decibels (between –15 and +12 decibels for the subwoofer). Note that the speaker volumes will return to the original settings when the TX-NR1000/TX-NR5000E is put in the standby state.

1	Press the scroll wheel to enter the
	AMP mode.
2	Press the [CH SEL] button and
	select the desired speaker.
CH SEL
3	Press the [LEVEL –] or [LEVEL +]
LEVEL- LEVEL+	button to adjust the volume level.

Note:

Remote controller

SLEEP

Press the scroll wheel, and then press the [SLEEP] button repeat- edly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute increments.

The [SLEEP] indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

Note:

If you are using the remote zone (Zone 2 or 3), it will turn off at the same time as the main zone.

To cancel the sleep timer, press the [SLEEP] button repeatedly until the

[SLEEP] indicator disappears.

To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

You cannot select a speaker if it is set to “Not Used” in the Speaker Configuration Sub-menu of the Speaker/ Output Setup Menu.

53