EN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TRANSMISSION SIGNAL

 

 

 

 

 

 

 

 

 

 

The heart rate chest belt and watch have a maximum transmission

 

 

 

 

 

range of about 62.5 centimetres (25 inches). They are equipped

 

 

 

 

 

with the latest digital coding system to reduce signal interference

 

 

 

 

 

from the environment, as well as analog technology. For more

 

 

 

 

 

accurate readings use the digital transmission signal. You should

 

 

 

 

 

only switch to the analog transmission signal if the situation in point

 

 

 

 

 

2 occurs (see below). Your watch will advise you which system it is

 

 

 

 

 

using and the signal status by displaying the following icons:

NOTE Whenever the watch is searching for the chest belt signal (manual or automatic search), make sure that the chest belt is no further than 10 cm (4 inches) from the watch.

ICON

DESCRIPTION

 

 

Outside heart is flashing

Searching for a signal

 

 

Inside heart is flashing

A signal has been found and

 

the digital system is being

 

used

Heart is flashing

A signal has been found and

 

the analog system is being

 

used

 

No signal has been found

 

 

 

No signal has been found

 

 

NOTE To switch from digital to analog or analog to digital system, press the chest belt button for more than 4 seconds and then force a signal search.

IMPORTANT If the heart icon does not appear on the display or is not flashing because no signal has been found, force a signal search. See "Signal Search" section for how to do this.

In the event that you experience a weak signal or your signal is disrupted by interference in the environment, follow the instructions below to identify and resolve the situation.

1.The signal is weak - the watch heart rate monitor will only show "0":

Shorten the distance between the heart rate chest belt and watch.

Re-adjust the position of the heart rate chest belt.

Checktheconductivepadsaremoistenoughtoensuresolidcontact.

Check the batteries. If they are low or exhausted, the range may be less.

Force a signal search (see "Signal Search" section).

12

SE212 English R7 OP_OK.p65

12

2006.1.6, 1:53 AM

Page 12
Image 12
Oregon Scientific SE212 / SE232 user manual Transmission Signal, Icon Description