Ositech comm 614006-001 manual Microsoft Workgroup Connection for DOS, DOS\NET Start

Section Three

Microsoft Workgroup Connection for DOS

To install Workgroup Connection for DOS, the Trumpcard driver diskette contains the required files to allow the installer to import an OEM diskette.

1.Run SETUP from MSWGCN Workgroup Connection diskette.

2.When prompted to select a Network card, select

“Network card not shown on list below...”

3.When prompted for the location (path) of the OEM driver, insert the Trumpcard driver diskette and enter A:\WFW\31

4.Press ENTER to select the highlighted entry: Ositech Trumpcard

5.Continue with the installation, if prompted to re-insert the OEM driver diskette be sure to enter the location (path) A:\WFW\31 as well.

The following are examples of changes made to the CONFIG.SYS, AUTOEXEC.BAT and PROTOCOL.INI

CONFIG.SYS

DEVICE=C:\DOS\PROTMAN.DOS /I:C:\DOS

DEVICE=C:\DOS\WORKGRP.SYS

DEVICE=C:\DOS\OTCETH.DOS

AUTOEXEC.BAT

C:\DOS\NET START

PROTOCOL.INI

[Network.setup]

version=0x3110

netcard=ms$otceth$nic,1,MS$OTCETH$NIC transport=ms$netbeui,MS$NETBEUI lana0=ms$otceth$nic,1,ms$netbeui

[protman] DriverName=PROTMAN$

PRIORITY=MS$NETBEUI

[MS$OTCETH$NIC]

DriverName=OTCETH$

MEM=0xc800

Interrupt=5

IOBase=0x300

3 - 14 Trumpcard Ethernet LAN