Inserting/removing an SD card
When using a non Panasonic SD card for the first time, or one which was previously used on another equipment, it is necessary to format the SD card. (l 28) When the SD card is formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Caution:
Check that the access lamp has gone off.
Access lamp A
≥ When this unit is accessing the SD card,
|
| the access lamp lights up. | |
|
| 1 Open the SD card slot cover and | |
|
| insert (remove) the SD card into | |
|
| (from) the card slot B. | |
|
| ≥ One SD card can be inserted into each of the | |
|
| card slot 1 and the card slot 2. | |
|
| ≥ Face the label side C in the direction shown | |
|
| in the illustration and press it straight in as far | |
|
| as it will go. | |
| | ≥ Press the center of the SD card and then pull | |
it straight out. | |||
| |||
|
| 2 Securely close the SD card slot | |
|
| cover. | |
|
| ≥ Securely close it until it clicks. |
≥Do not touch the terminals on the back of the SD card.
≥Do not apply strong shocks, bend, or drop the SD card.
≥Electrical noise, static electricity or the failure of this unit or the SD card may damage or erase the data stored on the SD card.
≥When the card access lamp is lit, do not: jRemove the SD card
jTurn the unit off
jInsert and remove the USB cable
jExpose the unit to vibrations or shock Performing the above while the lamp is on may result in damage to data/SD card or this unit.
≥Do not expose the terminals of the SD card to water, dirt or dust.
≥Do not place SD cards in the following areas: jIn direct sunlight
jIn very dusty or humid areas jNear a heater
jLocations susceptible to significant difference in temperature (condensation can occur.)
jWhere static electricity or electromagnetic waves occur
≥To protect SD cards, return them to their cases when you are not using them.
- 17 -