∫Using
The files can be transferred directly from the
≥Install the software supplied with the
Select the menu.
MENU : [SW & DISP SETUP] #
≥The mode is available only when
≥The mode will be canceled using the following steps. jWhen the unit is turned off
jIf you start recording motion picture
In addition to the steps above, the mode may also be canceled by the
≥When connected via
∫Selecting files to transfer
If you perform the required settings in advance on your PC, you can transfer selected files alone. For settings methods etc., please read the card operating instructions or consult the card manufacturer.
≥Install the software supplied with the
≥Change the mode to .
Select the menu.
MENU : [PICT. SETUP] # [TRANSFER/PROTECT]
≥The setting method is the same as that for the scene protect settings. (l 74)
≥If the selected transfer setting is not configured on the computer, [SCENE PROTECT] is displayed and the selected transfer setting cannot be configured.
≥When the write protect switch on the
≥The protect setting is also applied to the files for which [TRANSFER/PROTECT] is set. To delete a file, first cancel [TRANSFER/PROTECT] and then perform the operation.
∫Using the
You can select the maximum file size recorded on the
≥Change the mode to .
Select the menu.
MENU : [SW & DISP SETUP] #
[4GB]: The file is created with the maximum size of 4 GB. Set 2 GB since video files over 2 GB cannot be transferred.
[2GB]: The file is created with the maximum size of 2 GB.
≥When using the
- 87 -