Chapter 4 Checking operation using the pre-installation program
This chapter explains after the unit has been installed how to conduct comprehensive operation checks on the hardware of the unit using the limited edition of the editing software program which is
Note:
Do not install the editing program until the checks described in this chapter have been completed. Otherwise, it may no longer be possible to run the limited edition of the program which was
After the power to the unit has been turned on, wait until the Windows NT startup screen has appeared without any problem. It is only after this that all the checks described in this chapter are to be performed. For details on the checks and inspections before this screen appears, refer to Chapters 1 and 2 of this Manual.
When an external VTR is to be used, connect the external input and output devices to both the component and composite connectors before starting the checks.
16 |
4-1. Checking the uploading operation
Proceed with the checks in this section after the series of checks described in the previous chapters have been completed with no errors found.
In this section, the limited edition of the
If errors have been detected in the settings as a result of conducting the checks, refer to the explanations enclosed within the ¬ marks in the sections concerned in Appendix C and to the “Troubleshooting” section in the Operating Instructions. (Refer to pages
1.
(Startup may take ten seconds or so.)
– 16 –