After creating the video sequence, check its playback.
The function buttons (see figure at left) at the top of the sequence editor window are used for the playback operations.
20.Click the 
button to move the playback start position to the start of the video sequence.
21.The playback of the video sequence is started when the 
button is clicked.
22.The playback images are output to the video monitor.
23.While the video sequence is being played back, the playback position is indicated on the video track by the cursor.
24.Playback ends automatically when the end of the video sequence is reached.
25.To stop the playback at any time, click the 
button.
<Check> | ) Did the video sequence playback start when the | button was |
| clicked? |
|
) Did the video sequence playback stop when the 
button was clicked?
) Were the audio and video playback of the video sequence affected by noise or disturbances?
Check the playback images by viewing the video monitor.
After checking the editing operations in the video sequence, destroy the video sequence created.
26.Click the 
mark at the top right of the sequence editor window with the mouse.
27.The window shown below now appears.
28. Click the 
button to exit the sequence editor.
This completes the editing operation checks.
Do not exit the Toolbox since the limited edition of the editing software program will be used in the next section as well.
– 29 –