Parts and their functions

6Mounting bracket (installed)

7Tally lamp

This comes on or goes off in response to the control from the controller but only when “On” has been selected as the tally lamp use setting.

8G/L IN connector

This is the genlock signal input connector.

This unit supports the BBS or VBS signal as the genlock signal.

Connect it to the G/L OUT connector on the cable compensator (AW-RC400) or other unit.

9VIDEO OUT connector

This is the output connector for the camera’s composite video signals. Connect it to a monitor or other such device. Use a BNC coaxial cable as the connecting cable.

HD/SD ANALOG OUT connector

This is the output connector for the camera’s HD/SD component video signals.

Use a D-SUB 15-pin connecting cable (VGA cable) or DSUB 15-pin and BNC coaxial connector conversion cable as the connecting cable.

Use a high-quality cable.

Pin No.

 

Signal name

 

 

 

1

Pr

(In Y/C mode: C)

 

 

 

2

Y

(In Y/C mode: VBS)

 

 

3

Pb (In Y/C mode: Y)

 

 

4 to 15

GND

 

 

 

CONTROLLER connector

This is the input connector for the control signals of the camera unit or pan-tilt head unit.

Connect it to the [TO PAN/TILT HEAD] connector on the controller.

SERVICE switches

These switches are used for maintenance purposes. Keep them all at the “OFF” position.

IR ID SET switches

These are used to select the ID of the accessory wireless remote control.

Switches [1] to [4] correspond to the [CAM1] to [CAM4] buttons on the wireless remote control.

Wireless remote control signal light-sensing area (rear)

RESERVE button

This reserve button is used for maintenance purposes. It is not normally used by the user.

AC IN socket

Connect the accessory power cable to this socket.

Option slot

11

Page 11
Image 11
Panasonic AW-HE100N Mounting bracket installed Tally lamp, L in connector, Video OUT connector,  Controller connector