Genlock adjustment
When doing the adjustment
using the controller
The same operations as those in “When performing the operations using the accessory wireless remote control” can be performed following the operation procedure for “Basic menu operations” (pages 40 to 42).
When the
1 Press the [MENU] button.
2 Turn the jog dial (main) to display “G/L
SETTING” on the LCD panel.
3 Press the [OK] button, and display “H PHASE”.
4 Turn the jog dial (R) and adjust it to bring the horizontal phase into alignment.
Notes
When adjusting the horizontal phase using the controller, press the [MODE] button or [BAR/CAM] button to switch to “BAR” (the button’s lamp lights and color bars are displayed), and proceed with the adjustment. The horizontal phase cannot be adjusted in the “CAM” (camera picture) status.
After performing the adjustment, be sure to return to “CAM”. (The button’s lamp goes off.)
When horizontal phase adjustment is moved, color phase is also moved. Adjust color phase whenever horizontal phase adjustment is moved.
Color phase adjustment
The color phase adjustment must be performed if the pictures are to be switched using a video switcher or other device when the video output signals have been set as composite or Y/C signals.
It need not be performed when the video output signals have been set as component signals.
The camera’s color phase is aligned with the program output (split color bar output) signals of a color special effect device or other color tones that will serve as the reference. (The color phase can be adjusted more accurately if a vectorscope is used for the adjustment.)
Color bar of camera
Split line
Color bar of special effects generator
When performing the operations using the
accessory wireless remote control
1 Press the [MODE] button.
The mode is switched to the color bar display.
2 Set to the user mode by following the steps in “Selecting the shooting modes (scene files)” (page 20).
At this time, keep the “Mode Set”
The color phase adjustment is common to all shooting modes (scene files), but when the wireless remote control is used to perform the adjustment, the shooting mode must be selected. For this reason, either select the shooting mode which will be used subsequently or select the shooting mode again afterward.
Halogen
Mode Set
Brightness Set
Color Set
G/L, Setup Set
Other Set
Initialize
Return
Example: Halogen mode
38
