Panasonic AW-HE100N operating instructions How to turn the power on and off, Turning the power on

How to turn the power on and off

Turning the power on

When performing the operations using the

accessory wireless remote control

1 Set all the power switches of the units and devices connected in the system to ON.

This unit does not have a power switch.

When power is supplied to it, the status display lamp will light up orange.

2 Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.

3 Press the [ON/STANDBY] button on the wireless remote control for two seconds.

The power of the unit is turned on, and the initial settings operation is performed.

The unit’s status display lamp now lights up green.

4 If a multiple number of units are going to be used, repeat steps 2 and 3 as required.

The unit’s status display lamp blinks green when a signal matched by the remote control ID has been received, and it blinks orange when a signal that is not matched by the remote control ID has been received.

When performing the operations

using the controller

1 Set all the power switches of the units and devices connected in the system to ON.

This unit does not have a power switch.

When power is supplied to it, the status display lamp will light up orange.

2 Set the [OPERATE] switch on the controller to ON.

The power of all the cameras connected to the controller (including the unit) is turned on, and initial setup is performed.

The unit’s status display lamp now lights up green.

It takes about 30 seconds per unit for the initial settings operation to be completed. During this period, the unit cannot be operated.

Before setting the [OPERATE] switch on the controller to ON, be absolutely sure to set all the power switches of the units and devices connected in the system to ON.

For further details, refer to the Operating Instructions of the controller.

16