On-screen Display  (continued)

Time code (TC) display

( : ) NDF ( . ) DF

•Use the menu to display the time code for HD-SDI signal input. It also allows you to switch display mode (LTC, VITC, LUB, VUB). (→page 40)

In VITC and LTC display mode:

•Displays the time code as follows. hours: minutes: seconds: frames

•In drop-frame mode, a different delimiter between seconds and frames is used.

<Note>

Read errors are displayed as “--:--:--:--”

In VUB and LUB display modes:

•BG8, BG7, BG6, BG5, BG4, BG3, BG2, BG1 appear in the stated order.

BG: binary group

•The (:) delimiter does not appear.

<Note>

 

Read errors are displayed as “-- -- -- --

”

Closed caption (CC) display

Closed caption display area

Closed caption

display area

(When the specified window extends out of the entire screen)

•Closed caption can be displayed when SDI signals and VIDEO signals are input.

•Closed caption complies with the following standards.

•Composite Standard EIA/CEA-608 (VBI), OP-42

•SD-SDI CC Standard EIA/CEA-608 (ANC/VBI), OP-42

•HD-SDI CC Standard EIA/CEA-608 (708), EIA/CEA-708, OP-47

•In the case of EIA/CEA-708, multiple windows can be displayed at specified positions (up to 8).

•The display position is within a display area that is located in- side the entire screen. (Refer to the following notes.)

•The display settings can be configured in the menus. You can also select the type of closed caption, display channel (EIA/ CEA-608), and display service (EIA/CEA-708) in the menus. (→page 40)

<Note>

•The specified window position is displayed as a position within the display area depending on the closed caption information.

•The window may extend out of the display area depending on the specified window position and size. In such a case, the win- dow will be displayed but if the window also extends out of the entire screen, the display position of the window will be changed so that the window is displayed inside the entire screen.

In monitor display (IMD) display

• This monitor supports the TSL UMD PROTOCOL (Ver. 3.1 and Ver. 4.0) and allows you to display text and the tally indication on the monitor using the RS-485 interface.

• For information on how to set IMD and communications, refer to pages 41 and 46.

CAM1

Tally-1 TextTally-2

17