Panasonic BT-LH1850E, BT-LH1850P manual 26

Main menu  (continued)

Sub menu	Settings		Description
MONO *2	OFF	Switches between color and monochrome (MONO).
	ON	<OFF>	Color
		<ON>	Monochrome
		• When ON, the CHROMA setting of the picture adjusting knob is fixed at 0.
ANAMO *7	OFF	With an Anamo lens and HD-SDI input, the picture is resized to Anamo
	ON	magnification (the vertically enlarged signal can be vertically compressed and
		corrected for display).
SD ASPECT *2	4:3	Sets the aspect ratio for SD signal input.
	16:9	<4:3>	4:3 display
		<16:9> 16:9 display
SCAN *2*7	NORMAL	Sets under-scan and normal display.
	UNDER	<NORMAL> Normal display
		<UNDER> Under-scan

*2 This menu is grayed out when the same item is assigned to the GPI input terminal pin and GPI CONTROL is set to ENABLE. *7 “SCAN” changes are not reflected in Anamo size display.

IP mode

“MODE1” performs IP conversion using intra-frame interpolation. This monitor suppresses the delay to within 1 field.

The factory default is “MODE1”.

“MODE2” performs IP conversion using intra-field interpolation.

Since interpolation is performed only inside a field, this mode is suitable for checking interlace status.

„„WB (WHITE BALANCE) adjustment mode

Select “VAR1” to “VAR3” for “COLOR TEMP.” in the “VIDEO CONFIG” menu to make “WHITE BALANCE VAR1” to “WHITE BALANCE VAR3” (WB) adjustments.

				The underlined values are factory preset setting values.
Sub menu	Settings			Description
COLOR TEMP.*8	USER 0 - 63	Selects the color temperature that will become the basis for adjustment.
	D93	<USER 0 - 63>		Adjustable settings 0 - 63 (equivalent to a color temperature
	D65			range of 3,000 K - 9,300 K)
	D56	<D93>	Equivalent to a color temperature of 9,300 K
		<D65>	Equivalent to a color temperature of 6,500 K
		<D56>	Equivalent to a color temperature of 5,600 K
GAIN	▼	Adjusts the GAIN elements
		Press the rotary knob to switch to RGB direct adjustment mode.
		(This allows you to begin adjusting GAIN first.)
RED	0 - 1023	Displays the GAIN elements for RED. (For numerical value confirmation)
	(Factory defaults are
GREEN		Displays the GAIN elements for GREEN. (For numerical value confirmation)
	color temperature
BLUE	<D65> values.)	Displays the GAIN elements for BLUE. (For numerical value confirmation)
	• These are the
	adjustments made
	before shipment from
	the factory.
BIAS	▼	Adjusts the BIAS elements
		Press the rotary knob to switch to RGB direct adjustment mode.
		(This allows you to begin adjusting BIAS first.)
RED	- 512 - 511	Adjusts the BIAS elements for RED. (For numerical value confirmation)
	(Factory default: 0)
GREEN		Adjusts the BIAS elements for GREEN. (For numerical value confirmation)
BLUE		Adjusts the BIAS elements for BLUE. (For numerical value confirmation)
RESET	▼	Resets “GAIN RED” - “BIAS BLUE” to color temperature values selected under
		“COLOR TEMP.”

*8 Selecting “COLOR TEMP.” and pressing the rotary knob after making a change, opens a confirmation screen. Selecting “YES” and pressing the rotary knob in this screen resets selected GAIN and BIAS values to the selected color temperature values.

26