Panasonic BT-LH1850E, BT-LH1850P manual 35

Main menu  (continued)

„„WFM/VECTOR

The WFM/VECTOR function enables display of the waveform and vector display. Use DISPLAY SETUP in the main menu to select WFM and VECTOR display. (→page 40)

Press the button ([FUNCTION1] to [FUNCTION5] (→page 11)) to which the WFM/VECTOR function has been assigned to switch the display in the following order.

WFM/VECTOR OFF → WFM Y ON → WFM R ON → WFM G ON → WFM B ON → VECTOR (x1 to x8)

•This assumes that the WFM/VECTOR function has been assigned to any of the [FUNCTION1] to [FUNCTION5] buttons. WFM is displayed in the order of the Y signal, R signal, G signal, and B signal.

Press the FUNCTION button to which the WFM/VECTOR function has been assigned.

Normal screen	WFM display	VECTOR display*9
	(Y→R→G→B)
Press the		Press the
button again		button again

*9 Displayed only for SDI signal input.

•The scale display is as shown below.

100 %

50 %

0 %

				VECTOR
WFM (waveform
	display)			(vector display)
				These examples show 16:9 aspect ratio images.
				This dotted line is 109%.
			A dotted line indicates for
			each 10% increase.
				This dotted line is -4%.
		I axis
		The frame is ±2.5 degrees, ±2.5 %
		Q axis

35