Panasonic CF-VDW07HM Configure from AdHoc mode to Infrastructure mode, Method, IVReady to Connect

Infrastructure Mode Configuration

4.Enter the SSID as shown on the Wireless Dis- play. [ P.10-(2)]

5.Follow steps 11 and 12 on page 6 and 7 to exit out of the configuration utility. [ P.6- (11~12)]

This screen is a sample.

IInput the IP Address:

6.Follow steps 13 through 19 on pages 7, and 8 on how to enter the IP address. [ P.7-(13~19)]

IVReady to Connect:

7.The Wireless Display is now ready. Follow steps 20 through 22 on page 8 on how to establish connection with the computer. [ P.8-(20~22)]

Method 2

Configure from AdHoc mode to Infrastructure mode:

If the SSID of your Access Point is not "cfvdw07", you should first configure the Wireless Display with the computer in AdHoc mode. Secondly, use the "Wireless Display Setup Utility" to modify the Wireless Display to match the settings of the Access Point. Finally, change the wireless network adapter's profile to Infrastructure mode.

I Setup the Wireless Display in AdHoc Mode:

1.Follow the instructions on pages 3 through 8 on how to setup the display in AdHoc mode.

I Match the Display's Settings with the Access Point:

NOTE

Please have the information of your Access Point ready. The necessary information in- cludes the SSID of the Access Point, and it's WEP encryption key, if WEP is enabled.

Throughout this manual, an Access Point with

SSID = OfficeAP001

64 Bit WEP Key = A24BE4190C

is used as an example. Please match the settings accordingly with your Access Point.

11 Panasonic Wireless Display Configuration Manual