Panasonic DMC-GF1K operating instructions Start recording by pressing the motion picture button

Advanced (Recording pictures)

•The 20 mm/F1.7 interchangeable lens included in the DMC-GF1C utilises a lens drive system to realise a compact and bright F1.7 lens. As a result, sound and vibration may occur during focus operation, but this is not a malfunction.

•Operating sounds will be recorded when Auto Focus is performed during Motion Picture Recording. It is recommended to record with [CONTINUOUS AF] (P103) set to [OFF], if the sound of operation bothers you to avoid recording the lens noise.

•The 20 mm/F1.7 interchangeable lens included in the DMC-GF1C cannot be set to [AFC].

Start recording by pressing the motion picture button.

AElapsed recording time B Available recording time

• The audio is also recorded simultaneously from the built-in microphone on this unit. (Motion pictures cannot be recorded without audio.)

AC

B

•The recording state indicator (red) C will flash while recording motion pictures.

•Press the shutter button halfway when it is difficult to focus on the subject.

•You can also switch to Manual Focus by pressing [AF/MF] and selecting [MF] (P74).

Stop the recording by pressing the motion picture button again.

•Sound will go off when pressing the motion picture button indicating start/stop of motion picture recording.

Sound volume can be set in [BEEP] (P33).

•If the card becomes full in the middle of recording, the camera stops recording automatically.

Note

•The flash setting is fixed to [Œ].

•Available recording time is displayed when the [REMAINING DISP.] (P130) in the [CUSTOM MENU] menu is set to [REMAINING TIME].

•Refer to P191 for information about the available recording time.

•The available recording time displayed on the screen may not decrease regularly.

•Depending on the type of the card, the card access indication may appear for a while after recording motion pictures. This is not a malfunction.

•The operational sound of the zoom or button operation may be recorded when it is operated during the recording of a motion picture.

•Audio will not be recorded for 0.5 seconds after it starts recording if it is kept pressed. Release the motion picture button right after you press it.

•The screen may be blacked out momentarily, or the unit may record noise due to static electricity or electromagnetic waves etc. depending on the environment of the motion picture recording.

•When operating the zoom when recording motion pictures, it may take time to come into focus.

•If The Extra Optical Zoom was used before pressing the motion picture button, those settings will be cleared, so the focus range will change dramatically.

•When the aspect ratio setting is different in still and motion pictures, the angle of view changes

at the start of motion picture recording. When [ REC AREA] (P130) is set to [ ], angle of view during motion picture recording is displayed.

•The ISO sensitivity will be set to [AUTO] when recording motion pictures.

•When recording motion pictures, [STABILIZER] (Only available when a lens that supports the Stabilizer function is attached) is fixed to [MODE1].

•When recording motion pictures, the following functions cannot be used.

–[ ] and [ ] in [AF MODE]

–Direction Detection Function

VQT2G62 99