Panasonic DMC-GF1K Using the AC Adaptor, Connect the AC cable Connect the DC cable a

Others

∫About [LOCK] on the remote shutter

•You can keep the shutter button pressed fully. This is effective when taking pictures with Burst Mode (P66) or

in [B] (Bulb) (P87).

• While pressing the shutter button fully, slide it to the [LOCK] side.

•Slide it to the other side to cancel [LOCK].

Note

•Do not use any other remote shutters except DMW-RSL1 (optional).

•You cannot operate the camera with the remote shutter in the following cases.

– When the power save mode is cancelled

•Record with Motion Picture P Mode (P104) when using for motion picture recording. Motion picture recording can be started/stopped with the remote shutter.

Using the AC Adaptor

You can use the camera without worrying about battery discharge when it is connected to a PC or a printer if you use the DC cable (DMW-DCC3; optional) to connect the camera to the battery charger/AC adaptor and connect the AC cable.

•Check that the camera is turned off.

•Close the flash.

Connect the AC cable.

Connect the DC cable A.

• Pull open the DC cable cover 1 and then connect the DC cable to the camera body using the same steps as “Inserting and Removing the Card (optional)/the Battery” (P24). Pull the DC cable through the opening as shown in the illustration and then close the battery door 2.

• Be careful not to catch the DC cable (DMW-DCC3; optional) when closing the battery door.

• You cannot charge the battery if you connect the DC cable.

Note

•Do not use any other AC cables except the supplied one.

•Do not use any other cables except a genuine Panasonic DC cable (DMW-DCC3; optional). If you use other DC cables, it may cause a malfunction.

•The camera becomes warm during use. This is not a malfunction.

•Disconnect the charger/AC adaptor and DC cable when the camera is not in use.

VQT2G62 167