Advanced

Taking Pictures using Burst Mode

SCN1 SCN2

1 Press the burst mode button to switch the burst mode setting.

3

: High speed

;

: Low speed

;

: Unlimited¢1

;

No display: canceled

¢1 Depends on the memory size, battery power, picture size and quality (compression).

2 Take a picture.

Hold down the shutter button fully to activate the burst mode.

Number of pictures recorded in burst mode

Burst speed

Number of recordable

(pictures/

pictures (pictures)

second)

 

 

3¢2

max. 3

max. 5

2¢2

 

 

Depends on the approx. 2 remaining capacity of the

built-in memory/card.

¢2 The burst speed is constant regardless of the transfer speed of the card.

The number of pictures indicated is when the shutter speed is faster than 1/60 and the flash is not activated.

If you set the ISO sensitivity (P72) to [ISO400] or [ISO800] and then take

48

pictures using burst mode, the number of recordable pictures is less than indicated.

In simple mode [], the settings become as follows. [ ] appears on the left of the screen. (P28)

[ENLARGE]:

/Max. 3 pictures

[4qk6q/10k15cm]/[E-MAIL]:

/Max. 5 pictures

When the burst mode setting is set to Unlimited

You can take pictures until the capacity of the built-in memory or the card is full.

The burst speed will become slower halfway. When the built-in memory is used, the burst speed becomes a maximum of 1 picture approximately every 6 seconds. However, the exact timing of this depends on the number of recordable pictures and the card.

The focus is fixed when the first picture is taken.

When the self-timer is used, the number of recordable pictures in burst mode is fixed to 3.

Burst mode is not canceled when the camera is switched off.

When auto bracket and burst mode are set simultaneously, auto bracket will be performed.

The exposure and the white balance vary depending on the burst mode setting.

When burst mode is set to [ ], they are fixed to the values set for the first picture.

When the burst speed is set to [ ] or

[ ], they are adjusted each time you take a picture.

When burst mode is set, the auto review function is activated regardless of the auto review setting. (The picture is not enlarged.) You cannot set the auto review function in the [SETUP] menu.

When burst mode is activated, [AUDIO REC.] cannot be used.

When the flash is activated or [STARRY SKY] in scene mode is selected, you can take only 1 picture.

VQT0V40

Page 48
Image 48
Panasonic DMC-TZ1 operating instructions Taking Pictures using Burst Mode, Max pictures 4qk6q/10k15cm/ E-MAIL