Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved.
V. MAINTENANCE
WARNING
To avoid severe personal injury, always remove the battery pack from the tool before starting any maintenance procedure.
CAUTION:
To assure product SAFETY and RELIABILITY, servicing should be performed by an autho- rized service center. Always insist on genuine Panasonic replacement parts.
Cleaning Tool
Keep your tool clean for good cutting perform- ance, and to help keep it safe to use.
Follow these steps:
1.Remove the battery pack from the tool.
2.Wipe the tool with a dry, soft cloth. Do not use a wet cloth or cleaning liquids.
They could damage the tool’s finish.
3.Be sure to rub off any oil or grease which could make the tool slippery or hard to handle.
4.Remove the blade and brush off any dust.
CAUTION:
To avoid injury or damage to the unit, never immerse any part of the tool in a liquid.
Transparent Guard
WARNING
If the guard is cracked, or is broken, take the tool to an authorized service center for replacement. Do not attempt to operate tool. It could result in serious personal injury.
Never use your tool with a damaged transparent guard or without the transparent guard installed. Flying chips could result in serious injury.
VI. ACCESSORIES
WARNING
•The use of any accessories not specified in this manual may result in fire, electric shock, or personal injury. Use recommended accessories only.
•Use of a blade on material that is thicker or thinner than that recommended for that blade will result in a rough cut, and could increase the risk of “kickback” or other injury.
•EY9PM13C
For cutting unhardened ferrous material Thickness of material
0.5 mm – 6.0 mm (1/32" – 1/4")
•EY9PM13D
For cutting unhardened thin ferrous thin material that clean cutting edge required
Thickness of material
0.5 mm – 6.0 mm (1/32" – 1/4")
•EY9PW13A
For cutting wood in general
•EY9PW13B
For cutting thin wood that clean cutting edge required
Recommended thickness of material up to 12 mm
•EY9PP13B
For cutting plastic
Recommended thickness of material acrylic and vinyl chloride plates:
2.0 mm – 5.0 mm (5/64" – 3/16")
corrugated pates, pipes
0.8 mm – 5.0 mm (1/32" – 3/16")
Vacuum hose adaptor (Optional accessory)
• EY9X012E
Rip Fence (Optional accessory)
•EY3500B7727
For convenience of rip cuts and repeated cut of uniform width
- 19 -
