Setup

2

Connection and recognition

 

 

 

After the software applications are installed, this unit must be connected to the PC and be correctly recognised by the PC.

Remove the supplied CD-ROM from your PC.

AUSB cable (supplied)

1 Connect this unit to the AC adaptor.

If a battery is used, operation is not possible when this unit is connected to a PC.

2 Turn on the unit.

This function is available in all modes.

3 Connect this unit to a PC.

Insert the USB connectors as far as they will go.

Do not use any other USB connection cables except the supplied one. (Operation is not guaranteed with any other USB cables.)

4 Select [PC CONNECT] and press the cursor button.

This unit is automatically detected by the PC.

When the unit is connected to a PC, the operation mode cannot be changed and its power cannot be turned off.

Disconnect the USB cable, before turning this unit off.

Do not disconnect the USB cable or the AC adaptor while the card access lamp is on or

card access icon ( ) appears on the LCD monitor. Doing so may damage the data.

If the driver has not been recognised properly

Use the following methods to enable it to be recognised.

Method 1:

Turn off the unit and your PC once and try verifying again.

Method 2:

Remove the SD card and try verifying again.

Method 3:

Try connecting the unit to another USB port on your PC.

To disconnect USB cable safely

1Double click the ( ) icon in task tray displayed on the PC.

Depending on your PC’s settings, this icon may not be displayed.

2Select [USB Mass Storage Device] and click [Stop].

3Verify [MATSHITA HDC-SD9/SD USB Device] is selected and click [OK].

99

VQT1N58

Page 99
Image 99
Panasonic HDC-SD9D operating instructions Connection and recognition