1. Introduction and Installation
10 For assistance, please visit http://www.panasonic.com/help

1.4.2 Rear view

* The pictured model is KX-FLM671.
Removing the shipping tape
Remove the shipping tape (1) before installation.
Note:
LShipping tape positions are subject to change
without notice.
Installation
1.5 Toner cartridge and drum unit
The supplied toner cartridge is a starter toner cartridge.
Caution:
LRead the following instructions before you begin
installation. After you have read them, open the
drum unit protective bag. The drum unit contains
a photosensitive drum. Exposing it to light may
damage the drum. Once you have opened the
protective bag:
Do not expose the drum unit to light for more
than 5 minutes.
Do not touch or scratch the green drum
surface.
Do not place the drum unit near dust or dirt,
or in a high humidity area.
Do not expose the drum unit to direct
sunlight.
LWe cannot be responsible for any damage to the
unit or degradation of print quality which may
occur from the use of a non-Panasonic toner
cartridge and drum unit.
LDo not leave the toner cartridge out of the
protective bag for a long time. It will decrease the
toner life.
LDo not add toner to the toner cartridge.
1Before opening the protective bag of the new toner
cartridge, shake it vertically more than 5 times.
2Remove the toner cartridge and drum unit from the
protective bags. Peel off the seal (1) from the toner
cartridge.
LDo not touch or scratch the green drum surface.
APower inlet
BUSB interface connector
CLAN interface connector (KX-FLM671 only)
DExternal telephone jack
ETelephone line jack
FSpeaker

A B FDE

C

1
1