2. Preparation
17
For assistance, please visit http://www.panasonic.com/help
2Preparation2For assistance, please visit http://www.panasonic.com/helpConnections and Setup
2.1 Connections
Caution:
LWhen you operate this product, the power outlet
should be near the product and easily
accessible.
*1 KX-FLM671 only
* The pictured model is KX-FLM671.
Note:
LIf any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
Using surge protectors
LThe warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using a surge protector (9).
If the unit shares a single telephone line with a DSL
service (KX-FLM671 only)
Fax transmission/reception may be unreliable, noise
interference may be heard during telephone
conversations, or Caller ID (page 46) may not function
properly. Please attach a DSL filter (j) to the telephone
line cord of the unit to prevent this. A DSL filter may be
available from your DSL service provider.
* The pictured model is KX-FLM671.
Using network router/network hub
LWe recommend using network routers/network hubs
(6) under secure network environments. Consult
your network administrator for firewall settings, etc.
LThe warranty does not cover damage due to security
problems or any inconveniences relating to it.
1Power cord
LConnect to a power outlet
(120 V, 60 Hz).
2Telephone line cord
LConnect to a single telephone line jack (RJ11C).
3[EXT] jack
LYou can connect an answering machine or an
extension telephone. Remove the protective
sheet if attached.
4Answering machine (not supplied)
5LAN interface connector*1
LRemove the protective sheet if attached.
6Network router/Network hub (not supplied)*1
LAlso connect networked computers.
7To the Internet*1
8LAN cable (not supplied)*1
LTo assure continued emission limit compliance,
use only shielded LAN cable (Category 5 (Cat-5)
Ethernet cable).
9
7
1
4
2
8
6
35
IMPORTANT NOTICE FOR THE USB
CONNECTION
LDO NOT CONNECT THE USB CABLE UNTIL
PROMPTED TO DO SO DURING THE SETUP
OF MULTI-FUNCTION STATION (page 23).

j