| 9. Help |
|
|
|
|
9.3.2 General |
|
|
|
Problem | Cause & Solution |
The unit displays “PAPER | L You forced the recording paper into the paper tray too strongly. Remove all |
JAMMED” even though paper | of the installed paper, and |
is installed. |
|
The unit displays “CHECK | L The paper is inserted halfway. Insert it correctly (page 50) and press {SET} |
PAPER” even though paper is | to clear the message. |
inserted. |
|
The other party complains | L FAX ONLY mode is set. Tell the other party the number is only used for |
they only hear a fax tone and | faxes. |
cannot talk. | L Change the receiving mode to TAM/FAX mode (page 28) or TEL mode |
| (page 27). |
| L If you use a Distinctive Ring service, make sure you have set the same ring |
| pattern assigned by the telephone company (page 30). |
|
|
{REDIAL} or {PAUSE} does | L If this button is pressed during dialing, a pause will be inserted. If pressed |
not function properly. | immediately after a dial tone is obtained, the last number dialed will be |
| redialed. |
|
|
The receiving mode does not | L Distinctive Ring is set (feature #31 on page 30). |
function properly. |
|
|
|
During programming, I | L All or part of the numbers are the same as another code or ID. Change the |
cannot enter the code or ID | number: |
number. | – remote operation ID: feature #11 on page 37. |
| – fax activation code: feature #41 on page 40. |
|
|
The ink film runs out quickly. | L Even if there are only a few sentences, every page that comes out of the |
| machine is considered a full page. |
| L Turn OFF the following features: |
| – confirmation report: feature #04 on page 37. |
| – journal report: feature #22 on page 38. |
| – Caller ID list: feature #26 on page 38. |
|
|
The unit beeps. | L The memory reception alert of feature #44 is ON (page 40), and the unit has |
| a document in memory. Press {STOP} to stop the beeps, then see the |
| displayed message instructions to solve the problem. |
|
|
Whenever I try to retrieve my | L You are probably entering {*}{#}{9}. This is the default setting for the fax |
voice mail messages, I am | activation code. If you use a voice mail service, turn the fax activation |
interrupted by the fax tone. | feature OFF or reprogram the activation code (feature #41 on page 40). |
|
|
The speakerphone is not | L Use the speakerphone in a quiet room. |
working. | L If you have difficulty hearing the other party, adjust the volume. |
|
|
The unit does not display the | L You need to subscribe to a Caller ID service. |
caller’s name and/or | L Other telephone equipment may be interfering with your phone. Disconnect |
telephone number. | it and try again. |
| L Other electrical appliances connected to the same outlet may be interfering |
| with the Caller ID information. |
| L Telephone line noise may be affecting the Caller ID information. |
| L The caller requested not to send his/her information (page 20). |
|
|
The display exits the Caller ID | L Do not pause for over 3 minutes while viewing. |
list while viewing caller |
|
information. |
|
|
|
For assistance, please visit http://www.panasonic.com/help | 45 |
