1M N (right soft key) #131
RAll handsets registered to the base unit
are displayed.
2MbN: Select the handset you want to
cancel. a MOKN
3MbN: “Yes” a MOKN
RA confirmation tone sounds.
RThe handset does not beep when
cancelling its own registration.
4MeN
Increasing the range of the baseunit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
RBefore registering the repeater to this base
unit, you must turn the repeater mode on.
RDo not use more than one repeater at a
time.

Setting the repeater mode

1MN (right soft key) #138
2MbN: Select the desired setting. a MOKN
a MeN
Note:
RAfter turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once is displayed.

Registering the DECT repeater

(KX-A405) to the base unit

Note:
RPlease use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1Base unit:
Proceed with the operation for your model.
nKX-TG7851 series: page 3
Press and hold M N for about 5
seconds. (No registration tone)
nKX-TG7861 series: page 3
Press and hold MN for about 5
seconds, until the registration tone
sounds.
RThe next step must be completed
within 90 seconds.
2DECT repeater:
Connect the AC adaptor, then wait until
the indicator and indicator light
green.
3Base unit:
To exit the registration mode, press MN.
RThe registration tone stops.
(KX-TG7861 series: page 3)
33
Programming
TG7851_61FX(en)_0215_ver011.pdf 33 2013/02/15 18:28:13