Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
General use
Problem Cause/solution
The handset does not
turn on even after
installing charged
batteries.
RPlace the handset on the base unit or charger to turn on the
handset.
The unit does not work. RMake sure the batteries are installed correctly (page 10).
RFully charge the batteries (page 11).
RCheck the connections (page 10).
RUnplug the base unit’s AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
RThe handset has not been registered to the base unit. Register
the handset (page 32).
The handset display is
blank or dark.
RThe handset is in screen saver mode (page 14). Activate the
handset display again by:
– pressing MN when on a call.
– pressing MeN at all other times.
R“LCD in charging” is set to “Off” while on charge. Change
the setting (page 26).
RThe handset is not turned on. Turn the power on (page 15).
I cannot hear a dial tone. RMake sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
RThe base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
RDisconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your service provider/telephone company.
Programmable settings
Problem Cause/solution
The display is in a
language I cannot read.
RChange the display language (page 15).
I cannot activate the eco
mode.
RYou cannot set eco mode when you set the repeater mode
“On”. If required, set the repeater mode to “Off” (page 33).
49
Useful Information
TG7851_61FX(en)_0215_ver011.pdf 49 2013/02/15 18:28:14