Panasonic NV GS 330 To cancel Quick Start, ≥Set to Tape/Card Recording Mode

Before using

Quick Start

When quick start is ON the battery power is still being consumed, even when the LCD monitor and the viewfinder are closed.

The movie camera will resume recording/pause mode about 1.7 seconds after the LCD monitor or the viewfinder is reopended.

≥Please note in quick start mode approximately half the pause recording power is being consumed. Using quick start mode will reduce the battery recording/playback time.

≥This is only activated in the following cases. ≥While using the battery

A tape or a card is inserted, while the Tape Recording Mode is set.

A card is inserted, while the Card Recording Mode is set.

≥While using the AC adaptor

quick start can be used even if a tape/card is not inserted.

≥Set to Tape/Card Recording Mode.

1Set [SETUP] >> [QUICK START] >> [ON]. (-19-)

2While the [OFF/ON] switch is still set to [ON], close the LCD monitor and retract the viewfinder.

OFF ON

≥The Status indicator lights green and the unit goes into quick start standby mode.

≥The movie camera will not go into quick start standby unless the LCD monitor is closed and the viewfinder is retracted.

3Open the LCD monitor or extend the Viewfinder.

OFF ON

≥The Status indicator lights red and the camera is put into recording pause approx. 1.7 seconds after it is turned on.

ªTo cancel Quick Start

1Set [SETUP] >> [QUICK START] >> [OFF]. (-19-)

≥If the [OFF/ON] switch is set to [OFF] while the unit is in quick start standby, the power turns off.

≥If the standby continues for approx. 30 minutes, then the status indicator will go off and the camera will be completely turned off.

≥In the following cases, quick start is cancelled and the power turns off.

≥When the Mode dial is moved.

≥When the battery or AC adaptor is removed. ≥When both the tape and card are removed while using the battery in Tape Recording

Mode.

≥When the card is removed while using the battery in Card Recording Mode.

≥When the camera is quick-started with the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the colour night view function is used, however, the white balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby, the zoom magnification becomes 1k and the picture size may differ from what it was before quick start standby.

≥If [POWER SAVE] (-65-) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, set the [OFF/ON] switch to [OFF], then to [ON] again. Also, close the LCD monitor and retract the viewfinder and then open the LCD monitor or extend the viewfinder again.

14

VQT1L48