About Your Projector
Remote control
(18)
(9) <VOLUME> Buttons
Adjusts the volume of the speaker. (Æpage 34)
(1) | (10) | (10) |
Turn the projector on or off. (Æpage 28)
(2) |
| (11) <KEYSTONE> Button | ||
| Correct keystone distortion. (Æpage 33) | |||
|
| (12) | <INFO.> Button | |
|
| Operate the information function. (Æpage 33) | ||
(3) |
| (13) | <LAMP> Button | |
| Select a lamp mode. (Æpage 34) | |||
|
| |||
|
| (14) | ||
(4) | (11) | Operate the | ||
(15) | <P IN P> Button (Only for | |||
|
| |||
(5) | (12) | Operate the Picture In Picture function. (Æpage 35) | ||
(6) | (13) | (16) | <IMAGE> Button | |
Select the image mode. (Æpage 35) | ||||
(7) | (14) | (17) | <MUTE> Button | |
(15)* | ||||
Mute the sound. (Æpage 35) | ||||
(8) | (16) | |||
(18) | Remote control signal emitter | |||
(17) | ||||
|
|
| ||
(9) | Attention | |
zzDo not drop the remote control. | ||
| ||
| zzAvoid contact with liquids. | |
| zzDo not attempt to modify or disassemble the remote | |
| control. |
Preparation
*<P IN P> Button is only for
(1) <AUTO SET> Button
Execute the setting of Auto setup in the setting menu. (Æpage 52)
(2)Input Selection Buttons: <COMPUTER 1>, <COMPUTER 2>, <HDMI>, <VIDEO>,
These buttons are used to select the input signal. (Æpage 32)
(3)▲▼◄► Buttons, <SELECT> Button
Navigate the MENU display. (Æpage 36)
(4)<SCREEN> Button
Select a screen mode. (Æpage 48)
(5) <MENU> Button
Open or close the
(6) <FREEZE> Button
Pauses the projected image and sound tentatively. (Æpage 33)
(7) <AV MUTE> Button
Temporarily turn off the image on the screen. (Æpage 34)
(8)<D.ZOOM ▲▼> Buttons
Zoom in and out the images.
Note
zzThe remote control can be used within a distance of about 5 m (16.4 ft) if pointed directly at the remote control signal receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.
zzIf there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
zzYou can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light caused by the properties of the screen.
zzWhen the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set the projector as far from the luminous source as possible.
ENGLISH - 17