LAMP REPLACE andLAMPWARNINGREPLACE andIndicatorsWARNING Indicators
Managing the indicated problems
If a problem should occur inside the projector, the <POWER>, <LAMP REPLACE> and/or <WARNING> indicators will inform you. Manage the indicated problems as follow.
CAUTION
zzBefore you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”. (Æpage 30)
zzIf multiple indicators light or blink, verify the status of the projector by looking at each indicator.
Note
zzConfirm the status of the power indicated on the <POWER> indicator.
JJLAMP REPLACE indicator
Indicator Lighting in yellow
Status The projection lamp reaches its end of life.
Check Is there a Lamp replacement icon appears on the screen?
Remedy Replace the lamp unit. (Æpage 65)
Note
zzContact your dealer for repair services when <LAMP REPLACE> indicator persists to light after taking these measurements.
JJWARNING indicator
Indicator | Lights in red. | Blinks in red. | |
Status | The projector detects an abnormal | The temperature inside the projector is abnormally high. | |
condition and cannot be turned | The projector cannot be turned on. And the <POWER> | ||
| on. | indicator also blinks in red. | |
|
| - Did you provide appropriate space for the projector to be | |
| Unplug the AC power cord | ventilated? Check the installing condition to see if the air | |
Check | vents of the projector are not blocked. | ||
and plug it again to turn on the | |||
- Has the projector been installed near an Air- | |||
| projector. | ||
| Conditioning/ Heating Duct or Vent? | ||
|
| ||
|
| - Are the filters clean? | |
| If the projector is turned off again, | - Provide good installing condition to your projector. | |
Remedy | unplug the AC power cord and | - Move the installation of the projector away from the duct | |
contact the dealer or the service | or vent. | ||
| |||
| center for service and checkup. | - Replace filters. |
Note
zzIf <WARNING> indicator persists to light or blink after taking these measurements, please contact your dealer for repair services. Do not leave the projector on. It may cause an electric shock or a fire hazard.
zzThe projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center for service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.
Maintenance
ENGLISH - 61