JJSubpicture size

1111Press ▲▼ to select [Subpicture size] and then press the <SELECT> button.

2222Press ▲▼ to select one among the items as below.

zzYou can change the subpicture size among Small, Middle and Large.

JJSubpicture position

1111Press ▲▼ to select [Subpicture position] and then press the <SELECT> button.

2222Press ▲▼ to select one among the positions as below.

zzYou can adjust the subpicture position. (the bottom right, the top right, the top left and the bottom left).

Attention

zz[Subpicture size] and [Subpicture position] works only under P IN P mode.

zzThe P IN P function is not available depending on the input signals and the selected input terminals.

zzWhen the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

1111Press ▲▼ to select [Power management].

2222Press ► or the <SELECT> button to access the submenu.

JJMode

1111Press ▲▼ and then press the <SELECT> button to select one mode among the items as below.

Ready

When the lamp has been fully cooled

 

down, the <POWER> indicator

 

changes to green blinking. In this

 

condition, the projection lamp will

 

be turned on if the input signal is

 

reconnected or any button on the

 

control panel or remote control is

 

pressed

Shut

When the lamp has been fully cooled

down

down, the power will be turned off.

Off

[Power management] function is off.

Setting

JJTimer

1111Press ▲▼ to select [Timer] and then press the <SELECT> button.

2222Press ▲▼ to set the Timer(1~30min).

Direct on

1111Press ▲▼ to select [Direct on] and then press the <SELECT> button.

2222Press ▲▼ to switch between On and Off.

zzWhen this function is set to [On], the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

zzBe sure to turn off the projector properly. If the projector is turned off in the incorrect sequence, the [Direct On] function does not work properly.

Standby mode

This function can set the electric power when the projector is standing by.

1111Press ▲▼ to select [Standby mode] and then press the <SELECT> button.

2222Press ▲▼ to switch between the items as below.

Eco

Restricts some functions in

standby mode to reduce power

 

consumption.

Network

Does not restrict functionality

even in standby mode

 

Note

zzWhen selecting [Network], the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

zzRefer to "Operating Instructions - Network Operations". zzIf Standby mode is set to [Eco], you cannot use network functions when the projector is standing by. Also, you

cannot use some RS-232C protocol commands.

zzIf set to [Network], you can use network functions when the projector is standing by.

Settings

ENGLISH - 55