Panasonic PV-DV852 Inserting a Button-type Battery, 15˚, Using the Remote Controller

ªInserting a Button-type Battery

	Before using the remote controller, insert the supplied button-type battery.
1	1 While pressing the Stopper 1, pull out the Battery Holder.

2Insert the button-type battery with the imprint (r) facing upward.

3Insert the Battery Holder into the Remote Controller.

≥When the button-type battery becomes weak, replace it with a new CR2025 battery. (A battery is normally expected to last about one year. However, it depends on operation frequency.)

1≥Be sure to match the poles properly when inserting the battery.

2	.....................................................................................................................................................................
	Warning
	Danger of explosion if battery is incorrectly replaced.
	Replace only with the same or equivalent type recommended by the
	equipment manufacturer. Discard used batteries according to
	manufacturer’s instructions.
	Risk of fire, explosion and burns. Do not recharge, disassemble, heat
	above 212° F (100° C) or incinerate. Keep the Button-Type battery out of
3	the reach of children. Never put Button-Type battery in mouth. If
	swallowed, call your doctor.
	.....................................................................................................................................................................
	Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only.
	Use of another battery may present a risk of fire or explosion.
	Caution: Battery may explode if mistreated.
	Dispose of used battery promptly. Keep away from children.
	Do not recharge, disassemble or dispose of in fire.

1

15˚
15˚
	15˚
15˚
	DATE/	PHOTO	START/
OSD			STOP
	TIME	SHOT
COUNTER RESET		TITLE	ZOOM
MULTI/			T
	¥REC	A.DUB
P-IN-P			r
			sVOL
V/REW	PLAY	FF/W	W
6	1	5
STILL ADV	PAUSE	STILL ADV
E	;	D
INDEX	STOP	INDEX
K	∫	L
SELECT	VAR.		P.B.
	SEARCH		ZOOM

2STORE

	MENU
OFF/ON	SET
P.B.DIGITAL	ITEM

~~~~~~~~~~~~~~~~~~~~~~~~~

ªUsing the Remote Controller

1Direct the Remote Controller at the Remote Control Sensor

on the Palmcorder and press the desired button.

≥Distance from the Palmcorder: Within approximately 15 feet (5 meters)

≥Angle: Approximately 15 degrees in the vertical and horizontal directions from the central axis

≥The above operating ranges are for indoor use. Outdoors, or under strong light, the equipment may not operate properly even within the above ranges.

≥Within 3 feet (1 meter) range, you can also use the Remote Controller on the side (the LCD Monitor side) of the Palmcorder.

Selecting Remote Controller Modes

When two Palmcorders are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.

≥If the Remote Controller Mode on the Palmcorder and Remote Controller do not match, [REMOTE] is displayed.

	Setting on the Palmcorder:
	Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired
	Remote Controller Mode.
	Setting on the Remote Controller:
1	[VCR1]: Press the [D] Button and [∫] Button simultaneously. 1
	[VCR2]: Press the [E] Button and [∫] Button simultaneously. 2
	≥When the battery in the Remote Controller is replaced, the Mode is
	automatically reset to [VCR1] Mode.

11