![](/images/new-backgrounds/1318453/318453113x1.webp)
With a PC
Using Quick Movie Magic or MotionDV STUDIO
When the OS is Windows 2000/XP, the Camcorder can be connected to the personal computer with the DV cable.
When the OS is Windows 2000/XP, the Camcorder can be connected to the personal computer with the USB cable. However, when the OS is Windows 2000, USB driver must be installed.
≥Do not connect the USB cable until the USB driver is installed.
ªOperating environment
OS:
IBM PC/AT compatible personal computer with
Microsoft Windows XP Home Edition/ Professional SP2
Microsoft Windows 2000 Professional SP4
CPU:
Intel Pentium III 800 MHz or higher (including compatible CPU)
Graphic display:
High Color (16 bit) or more (32 bit recommended)
Desktop resolution of 1024k768 pixels or more (Supporting the overlay of DirectDraw)
Sound:
PCM sound source (Compatible DirectSound)
RAM:
256 MB or more
(Adding more memory enables you to operate the personal computer more comfortably.)
Hard disk:
Ultra DMA – 33 or more
Free hard disk space:
640 MB or more
(When you capture video, 1 GB is needed for data of approx. 4 minutes.)
Interface:
DV (IEEE1394) terminal (IEEE1394.a) USB terminal
Necessary software: DirectX 9.0b/9.0c
Windows Media Player 6.4 to 10
Other requirements: Mouse
≥This software is not compatible with a multi-
CPU environment.
≥This software is not compatible with a
environment.
≥Operation on Microsoft Windows XP Media Center Edition, Tablet PC Edition and 64 bit operating system is not guaranteed.
ªInstalling USB Driver
Install this when your OS is Windows 2000 SP4. (When your OS is Windows XP SP2, installing USB driver is not needed.) USB Driver must be installed when you connect the Camcorder to the PC with the USB cable and use Quick Movie Magic or MotionDV STUDIO.
DirectX 9.0b is installed in your PC if it is not installed beforehand.
≥When DirectX 9.0b is installed, applications supported by previous versions of DirectX may not run. In this case, consult the manufacturers of the applications disabled.
1Insert the supplied
≥Quit all applications. ≥[Setup Menu] appears.
2Click [USB Driver].
≥The set up program starts running.
3Depending on your system environment, installation of “DirectX9.0b” may be required. Click [Yes] and continue with installation.
≥After “DirectX 9.0b” is installed, the computer will restart.
≥Do not remove the
≥Installation may take a little while.
4 Finish installation by following the on-screen instructions.
≥Click [Next] and proceed with installation. ≥After completing the installation, Click
[Finish].
5Click [OK].
57
LSQT1091