Panasonic TY-CE42PS1, TY-WK42PV1 manual Fixing the wall-hanging bracket to the wall, 930 450 490

Instruction of the installation

Fixing the wall-hanging bracket to the wall

1 Check the strength of the installation location

The wall-hanging bracket weighs approximately 6kg, and the display unit by itself weighs 33kg. Refer to the wall-hanging bracket installation dimensions in the diagram below to, check the strength of the wall in six installation locations, and add reinforcement if any of these locations are not strong enough.

1)Select an installation site with an area of at least 1,500 mm wide by 800 mm high. Refer to the figure to make a positioning mark for the location of the center-top hole.

2)Measure and mark the locations 450 mm to the left and 450 mm horizontally to the right of the location you marked in 1).

3)Measure and mark the locations 450 mm below each of the marked location.

Units : mm

Used for routing wires behind a wall

930

15 450 450 15

20

490	450
		100	50
		50
	20	30

Wall installation holes(6 locations)

The wall-hanging bracket has installation holes provided at 24 locations.

If the wall material does not allow sufficient strength by using six installation holes, use s o m e o f t h e s p a r e holes.

However, depending on t h e c o n s t r u c t i o n material used at the place of installation, cracks may develop if the screws are inserted too close to each other.

4-4