2 Fix a M6 screw, through any of the slits in the bracket, into the corresponding hole in the wall.

Using a level along the top or bottom edge, ensure that holding bracket is horizontal.

The holding bracket must always be installed. It prevents the display unit from falling after installation.

3

Fix the screws through the slits into the remaining three holes.

4

Provisionally tighten the fixing screws.

Fixing the insulating spacers to the display unit

1

1)

Spread a clean cloth over a level floor or base, and place it on the

 

display unit face down.

 

2)

Remove the screws and covers.

 

 

Keep them in a safe place for possible future use.

If the screws protrude more than 5 mm, it will n o t b e p o s s i bl e t o proper ly install the display unit.

Carefully place the Wide Plasma Display face down on top of a clean cloth, which has been s p r e a d o ve r a f l a t surface with no other objects on it, and then proceed to the next step.

2-4

Page 18
Image 18
Panasonic TY-WK42PV1 manual Fixing the insulating spacers to the display unit, Provisionally tighten the fixing screws