Panasonic WJ-MPU955A Matrix Switcher WJ-SX650Series, Network Board Installation, Connect with CPU

Connection with System Devices

■System Controllers

Regarding system controllers, the connection and setup are same as the GX system. (Refer to p. 28.)

■Matrix Switcher WJ-SX650 Series

●Network Board Installation

The back panel (OUT X-1) of Video Output Board 1 should be replaced by Network Board WJ-PB65E01.

●Connect with CPU

The matrix switchers connect with the CPU through its Ethernet port and one or more switching hub units. This system can support up to six WJ-SX650 SubNodes. The CPU assigns the IP address to each sub node based on the admin console data- base.

SX650 SubNode 1 SX650 SubNode 2

192.168.200.1

SX650 SubNode 4

192.168.200.4

SX650 SubNode 3

192.168.200.3

192.168.200.2

SX650 SubNode 5

192.168.200.5

SX650 SubNode 6

192.168.200.6

192.168.200.200
10BASE-T/100BASE-TX	SERIAL	POWER
		ON
		OFF
SYSTEM SYSTEM OTHER	2	1

CONTROLLER DEVICE

AC IN

SIGNAL GND

Switching HUB

WJ-MPU955A

This illustration shows the network connection only. (This is not the whole connection.)

36