Installation of Auto Iris Lens Connector

(2) Solder the lens cable to the pins of the supplied

Install the lens connector (YFE4191J100) when using a

connector.

 

video drive ALC lens.

 

The installation should be made by qualified service personnel or system installers.

(1)Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and then remove the outer cable cover as shown in the diagram below.

The pin assignment of the lens connector is as fol- lows:

Pin 1: Power source; +9 V DC, 50 mA Max.

Pin 2: Not used

Pin 3: Video signal; 1.3 V [p-p]/40 k

Pin 4: Shield, ground

Pin 3

Pin 1

Rib

Pin 4

Pin 2

-11-

Page 11
Image 11
Panasonic WV-CL924, WV-CL920 operating instructions Installation of Auto Iris Lens Connector