Panasonic WV-CL924, WV-CL920 operating instructions Burst BW

Default: OFF

AUTO1: The camera selects black and white mode if the picture is dark, or color mode if the pic- ture is bright enough.

Note: Color picture switches to black-and- white picture and vice versa in approxi- mately 1 or 2 minutes after recognition of illuminance.

AUTO2: Applying AUTO1 may cause malfunction when using a source of near-infrared light at night because the illuminance changes signifi- cantly when switching between the color pic- ture and the black-and-white picture. But AUTO2 allows the unit to prevent malfunction because it simply recognizes a source of light. Note: Because a source of light is simply rec-

ognized based on the information from CCD image pickup element, an object sometimes can not be recognized suc- cessfully when the object is always mov- ing or the object and its background have the same color.

When you apply this mode, AUTO2, the wavelength of the light source should be 800 nm or more.

ON: Black and white mode is selected.

OFF: Color mode is selected.

** SPECIAL **
UP SIDE DOWN	OFF
CHROMA GAIN	....I....
AP GAIN	....I....
PEDESTAL	....I....
HUE	....I....
BW	-	+
	OFF
BURST (BW)	ON
CAMERA RESET	PUSH SW
RET END

10.7 BURST (BW)

1.Move the cursor to the BURST (BW) parameter.

2.Select ON or OFF using or . Default: ON

ON: The burst signal is supplied along with the black and white composite video signal.

OFF: The burst signal is not output.

Note: We recommend that you usually select ON.

** SPECIAL **
UP SIDE DOWN	OFF
CHROMA GAIN	....I....
AP GAIN	....I....
PEDESTAL	....I....
HUE	....I....
	-	+
BW	OFF
BURST (BW)	ON
CAMERA RESET	PUSH SW
RET END

-38-