-25-
(2) Move the cursor to ZOOM, press the CAM (SET)
key, move the joystick to settle the ZOOM
position and return to the AUTO PAN menu. The
manual zoom operation is not available in the
TELE direction beyond the settled zoom
position.
OFF: Does not limit the manual zoom operation.
Notes:
•When the panning, tilting, zooming or focusing
in the SEQ, SORT or PATROL mode is controlled
manually, the auto mode function should be
cancelled.
To activate the auto mode, select the desired
auto mode again or set a time for SELF RETURN
in the SET UP menu.
•When 0S is selected, the camera stops without
dwelling and starts.
•Auto refreshing may be activated during the
patrol play or the auto mode to calibrate the lens
position.
■Auto Pan Key Setting (AUTO PANKEY)
This is used for assigning one of the following auto
functions to the AUTO key on the controller. Pressing
the AUTO key activates the assigned function after this
setting.
•Move the cursor to AUTO PAN KEY and select an
auto function with the joystick.
The factory default setting is AUTO PAN.
The mode changes as follows:
AUTO PAN: Assigns the auto panning function to
the key.
SEQ: assigns the SEQUENCE function to the key.
SORT: assigns the SORT function to the key.
PATROL: assigns the PATROL PLAY function to the
key.
Note: AUTO PAN LED on the controller does not
light if something other than AUTO PAN is
assigned. AUTO PAN does not stop with the
AUTO PAN key.
If PASSWORD LOCK is set to ON, you cannot
operate AUTO PAN, SEQ, SORT, and PATROL
even by pressing the AUTO key.
■Digital Flip Setting (DIGITAL FLIP)
•Move the cursor to DIGITAL FLIP and select ON or
OFF with the joystick.
OFF: The tilt range is limited from 0°to 90 °.
ON: The digital flip function allows the tilt angle to
widen up to 180°. The image on the monitor
screen is flipped horizontally and vertically at the
tilt angle of approx. 135°(If the camera is
installed on a ceiling).
Note: The tilt range narrows from 0°to 90 °if PAN
LIMIT is set to ON.
Notes:
•Digital flip functions while moving the joystick
downwards. In case of moving the joystick to other
directions, it does not function.
•When OFF is selected for DIGITAL FLIP, the
following operations are required to move the
camera 180°vertically.
1) Move the joystick downwards to aim the camera
down.
2) Move the joystick to the right or left to rotate the
camera 180°horizontally.
3) Move the joystick upwards.
•To set the preset position directly from WV-CU360
System Controller, it is temporarily required to set
both the electronic zoom function and digital flip
function to OFF.
Tilt range setting is disabled between 90°and 185 °.
** ZOOM LIMIT **
ZOOM
U ZOOM D
RET
→
PUSH SET
** SET UP MENU **
PRESET 1
MAP
HOME POSITION
SELF RETURN
AUTO MODE
AUTO PAN KEY
DIGITAL FLIP
SPECIAL1
CAMERA
RS485 SET UP
PASSWORD LOCK OFF
OFF
OFF
OFF
AUTO PAN
ON
SEQ SORT PATROL
AUTO PAN
** SET UP MENU **
PRESET 1
MAP
HOME POSITION
SELF RETURN
AUTO MODE
AUTO PAN KEY
DIGITAL FLIP
SPECIAL1
CAMERA
RS485 SET UP
PASSWORD LOCK OFF
OFF
OFF
OFF
AUTO PAN
ON