Panasonic WV-CS854B operating instructions Patrol-learn and Patrol Play Patrol, To Quit Editing

To Quit Editing

•To return to the AREA TITLE menu, move the cursor to RET, and press the CAM (SET) key.

•To cancel one area title, move the cursor to RESET in the AREA TITLE menu, and press the CAM (SET) key.

•To return to the SPECIAL 1 menu, move the cursor to RET, and press the CAM (SET) key.

•To erase all the area titles, move the cursor to RESET in the AREA TITLE (USER) selection menu, and press the CAM (SET) key.

FLOOR 1

NORTH

Notes:

•An area title appears under the camera ID if both are set in the same position. If the setting is different, they appear in the area title position.

•In case of sharing a common subject in a scene of other camera number, the nearest area title appears while the camera direction deviates within 45 ° from the set position. If two or more area numbers are set in the same position, the title of the highest number appears.

•IMAGE HOLD

•AREA TITLE

•DIGITAL FLIP

•PRIVACY ZONE

•CAMERA ID

•PROPO.PT

•PAN LIMIT

•ZOOM LIMIT

•TILT ANGLE

•BURST

•CLEANING

After starting the patrol-learn, the following manual operations are stored.

•PAN/TILT/ZOOM/FOCUS operation

•IRIS operation

•Preset positioning

2.Open the SET UP menu and move the cursor to SPECIAL 1. For PATROL, select LEARN, PLAY or STOP with the joystick.

The factory default setting is STOP.

LEARN: A series of manual operations is stored.

PLAY: Stored operations are reproduced.

STOP: LEARN or PLAY is not activated.

PATROL LEARN with a Controller Having PATROL Key

1.Press the PATROL key and the CAM (SET) key simultaneously to start patrol-learn. The setup menu displays "LEARNING(60S)", and the starting points are stored.

●Patrol-learn and Patrol Play (PATROL)

A routine of manual operations can be stored for 1 minute at the maximum and reproduced repetitively.

PATROL

** SPECIAL	1 **
PRIVACY ZONE	OFF
PROPO.P/T	ON
AREA TITLE	ON(USER)
PATROL		PLAY
ALARM IN/OUT
CLEANING	OFF
EL-ZOOM	ON
PRESET ALM	OFF
IMAGE HOLD	OFF
TILT ANGLE	0°
RET

1.Set the following parameters for the patrol-learn starting position. These parameters are stored when the patrol-learn mode starts.

•PAN/TILT/ZOOM/FOCUS

•IRIS

•SHUTTER

•AGC

•SENS UP

•WHITE BALANCE

LEARNING(60S)

2.Operate patrol-learn manually. The operation data is stored. The countdown to complete learning is displayed.

3.To stop patrol-learn, press the PATROL STOP key.

Patrol-learn with a Controller not Having the PATROL Key

1.Close the SET UP or SPECIAL 1 menu to start PATROL LEARN. Starting point parameters are stored and "LEARNING(60S)" is displayed on the monitor.

2.Operate patrol-learn manually.

-30-