Panasonic WV-CW864A RS485 Communication, Auto Focus AF Mode, 10Special 2 Menu SPECIAL2

(9)Auto Focus (AF MODE)

The camera adjusts the focus automatically by sens- ing the center of the picture. S, M and L stand for the size of the sensing area: Small, Middle and Large.

See page 40 for details.

MANUAL S, M, L: Auto-focus is activated only when the AF key on the controller is pressed.

AUTO S, M, L: Auto-focus is activated automatically while a manual pan, tilt or zoom operation is per- formed.

Note: If SENS UP is set to ON except x2 FIX or x2 AUTO, the AUTO (S/M/L) mode is disabled and the MANUAL (S/M/L) mode is automatically selected.

(10)Special 2 Menu (SPECIAL2)

This menu allows you to adjust and set up the fol- lowing items and functions: chroma level, aperture level and pedestal level.

You can also reset your parameters to the factory default settings.

See page 40 for the setting.

(11)Self-diagnosis Function

If the camera continues operating abnormally for 30 seconds or more due to such accident as external noise, the camera will automatically reset its power. In the case it happens frequently, check if there would be any environmental cause.

●RS485 Communication

Refer to the following pages for the communication parameter settings.

•Full/Half duplex (page 45)

•Transmission speed (4 900 - 19 200 bps) (page 45)

•Parity bit, Stop bit, Flow control (page 43)

•Wait time, Delay time, Alarm output (page 43)

•Camera units (96 units max.) (page 43)

•Termination ON/OFF (page 43)

•Reset parameters (page 43)

-16-