Panasonic WV-CW864A operating instructions Synchronization Sync, Line-lock Sync Mode LL

•When ON is selected for SUPER-D2 on the ALC CONT menu

OFF X2 AUTO X4 AUTO X6 AUTO X10 AUTO X32 AUTO X16 AUTO

Notes:

•When ON is selected for SUPER-D2 in the ALC CONT menu, FIX is not available for this item.

•When AUTO is selected for SENS UP and ON is selected for SUPER-D2, the SENS UP function has priority so that the SUPER-D2 function is not activat- ed automatically.

•While the SENS UP function is selected, noise or spots may appear in the picture when the sensitivity of the camera is increased. This is a normal phe- nomenon.

●Synchronization (SYNC)

Move the cursor to SYNC and select LL or INT with the joystick.

** SET UP **

CAMERA ID		OFF
ALC/MANUAL		ALC
SHUTTER		AUTO
AGC		ON(MID)
SENS UP		OFF
SYNC		INT
WHITE BAL		ATW1
MOTION DET		OFF
AF MODE		AUTO L
RET	SPECIAL2

Important Notices:

1.The priorities of SYNC modes are assigned as fol- lows:

1.Multiplexed vertical drive (VD2) (highest priority)

2.Line-lock (LL)

3.Internal sync (INT) (lowest priority)

2.To use internal sync, select INT.

3.Whenever the vertical drive pulse (VD2) is supplied to the camera, the camera sync mode is automati- cally switched to the multiplexed vertical drive pulse (VD2) regardless of the selected sync mode.

Line-lock Sync Mode (LL)

1.Move the cursor to SYNC and select LL with the joy- stick. The LL sync mode is not available when the multiplexed vertical drive (VD2) pulse is supplied.

2.After selecting LL, press the CAM (SET) key. The SYNC menu appears on the monitor screen.

** SET UP **

CAMERA ID		OFF
ALC/MANUAL		ALC
SHUTTER		AUTO
AGC		ON(MID)
SENS UP		OFF
SYNC		LL
WHITE BAL		ATW1
MOTION DET		OFF
AF MODE		AUTO L
RET	SPECIAL2

3.Supply the video output signal of the camera to be adjusted and the reference video output signal to a dual-trace oscilloscope.

4.Set the dual-trace oscilloscope to the vertical rate and expand the vertical sync portion on the oscillo- scope.

5.Move the cursor to COARSE with the joystick.

** SYNC **
V PHASE
COARSE	1	(1--16)
FINE	••••••••
	-		+

RET

6.Match the vertical phases for both video output sig- nals as closely as possible with the joystick. The coarse adjustment can be performed in steps of 22.5 degrees (16 steps) with the joystick.

1 (1 - - - 16): 0 degrees

2 (1 - - - 16): 22.5 degrees

16 (1 - - - 16): 337.5 degrees

Note: After the 16th step, the adjustment level returns to the first step.

7. Move the cursor to FINE by using the joystick.

** SYNC **
V PHASE
COARSE	1(1--16)
FINE
		••••••••
		-	+

RET

-37-