About the Auto-Tracking Function

The camera's auto tracking function operates by using image recognition. The client is responsible for understanding and applying the following warnings regarding installation and operation necessary to prevent losses due to malfunction or lack of detection as a result of unforeseeable aspects of the installation area.

The camera's tracking function is for monitoring unknown intruders. It is not suitable for locations with large numbers of people such as intersections or retail stores. Be sure to confirm this before installing the camera.

Be sure to set the height of the camera under the detailed settings (page 41) of the auto-tracking function.

Install the camera in a horizontal configuration, with the dome pointed downwards.

Install the camera securely so that it does not sway. High resolution operation may reduce performance.

The camera cannot track well horizontally or directly below itself, so avoid this type of installation.

Install the camera and adjust the view angle so that people do not move vertically on the screen. Vertical motion creates only small deviation on the screen and may not be detected.

Dirt or scratches on the dome cover make it difficult to see the image which may reduce performance. Periodically clean the dome cover.

Rain or snow on the dome cover may reduce performance. Consider placing the camera under eaves or some kind of cover.

Use the electronic sensitivity enhancement (page 29) if using the camera at night (approximately 10 lx).

Use the detection area mask (page 42) to avoid detection errors caused by the motion of trees or traffic.

Auto-tracking may start for vehicles or other non- human movements, however, this is not a malfunction. Adjust the view angle or use detection area masking (page 42).

Adjust the view angle or use detection area masking (page 42) if there is strong back lighting, neon lighting or other flashing lights, or reflection on glass or the surface of a road in the image.

To detect people, adjust the view angle so that the people are about 1/5 of the vertical height of the screen.

Periodically replace consumable parts (page 7).

The pan, tilt and zoom functions operate in unison to track moving subjects smoothly.

Precautions

1.Do not attempt to disassemble the camera.

To prevent electric shock, do not remove screws or covers.

There are no user-serviceable parts inside. Ask qualified service personnel for servicing.

2.Handle the camera with care.

Do not misuse the camera. Avoid striking, shaking, etc. The camera could be damaged by improper handling or storage.

3.Install the camera at a location that is able to support its total weight.

Installing at a location that is not strong enough can cause the camera to fall down or tip over. Be sure to reinforce weak locations sufficiently before installing the camera.

4.Use the fall-prevention wires to reduce the risk of the camera falling down.

Do not detach the fall-prevention wire securing the camera. Otherwise the camera could fall down, causing injury to persons and damage to the camera.

-6-

5.Never aim the camera at the sun.

Whether or not the camera is in use , never aim it at the sun or other extremely bright objects. Otherwise, blooming or smear may be caused.

6.Never aim the camera at strong light sources for an extended period of time.

A light source such as a spot light causes burn-in on the display screen. Failure to observe this may cause the image to become discolored due to deterioration of the color filter in the CCD.

7.Do not operate the camera beyond the specified temperature, humidity or power source ratings. Do not use the camera in an extreme environment where high temperature or high humidity exists. Do not place the camera near heat sources such as radiators, stoves or other units that produce heat. Use the camera under conditions where tempera- ture is between –40 °C to +50 °C {–40 °F to 122 °F} and humidity is below 90 %.

The input power source is 24 V AC 60 Hz.

Page 6
Image 6
Panasonic WV-CW974 About the Auto-Tracking Function, Precautions, Do not attempt to disassemble the camera