Panasonic WV-CW974 Configuring the Target Frame Setting INDICA- TOR, Candidate

(10)Configuring the Target Frame Setting (INDICA- TOR)

Use this setting to specify whether a target frame should be displayed around the target during auto tracking. The target frame can be used to specify the target being tracked during pan, tilt, and zoom operations.

1.Move the cursor to INDICATOR, and then tilt the joystick left or right to select a target frame.

OFF	: Turns off display of the target
	frame.
	This is the factory default setting.
CANDIDATE	: Displays a target assist frame dur-
	ing manual tracking. During manu-
	al operation,		is shown in the
	center of the	screen.
TARGET	: Displays a target frame during
	auto tracking. When movement is
	detected,	appears in the four
	corners of the screen. When auto
	tracking starts, an		frame sur-
	rounds the target.
ON	: Displays a CANDIDATE and TAR-
	GET target frame.

Note: When auto tracking starts while is displayed in the center of the screen, motion in the center of the screen is detected.

When auto tracking starts while is not displayed in the center of the screen, the motion in the entire screen is detected.

Important: About auto tracking

The following types of targets can cause operational errors or make tracking impossible.

•A target or background with low contrast

•Water or dirt on the dome

•An environment with extreme changes in illumination

•An environment where there is excessive other, non-target movement

•Movement along the camera's optical axis (vertical)

•Movement of the target in the vicinity directly below the camera

•An environment where there is extreme flickering

•Environments where there is light shining onto the dome from a window, reflected from a road surface, from back lighting, etc.

•Target becoming hidden by a utility pole or other object

•Target movement that is very fast or very slow

•An unsteady camera

Important:

In order to improve detection accuracy, it is recommended that the camera be used in an environment with the following conditions.

•Target size is approximately one-fifth (vertically) of the monitor screen.

•TILT angle is within the range of 20° to 55° (page 40).

-43-