Pantech WV-NW474S manual Image Adjustment, Video Output Connection, Control Connector

●Video Output Connection

Connect the video output cable to the monitor or other system device with the procured coaxial cable. The maximum extensible length is shown in the table.

Type of		RG-59/U	RG-6/U	RG-11/U	RG-15/U
coaxial cable		(3C-2V)	(5C-2V)	(7C-2V)	(10C-2V)
Recommended	(m)	250	500	600	800
maximum
cable length	(ft)	825	1 650	1 980	2 640

●Control Connector

Connect the respective peripherals to supply and receive control signals. Use the supplied 5-pin cable adapter. For electrical ratings, refer to SPECIFICA-

TIONS.

Pin#	Wire color	Function	Example of
			peripherals
1	Black	Alarm in	Door switch
2	Gray	Alarm out	Buzzer
3	Pink	AUX out	Lighting lamp
4	Red	Day/night in	Optical sensor
5	Green	GND	Signal ground

●Network Port Connection

Connect the network port to a PC or a network via a hub with a 10BASE-T/100BASETX cable. Use the sup- plied adapter (RJ-45, female-female) if necessary.

Note: For network system connections, refer to ■ Network Connection Types.

■Image Adjustment

You can manually adjust the pan/tilt/azimuth angles, focus, and zoom while observing the connected moni- tor.

Notes:

•Do not hold the camera by the lens unit when adjusting panning, tilting, or azimuth.

•The video output to the BNC will be interrupted while an LCD monitor is connected to the monitor output jack.

1.Connect an LCD monitor to the video jack.

2.Pan/tilt/azimuth adjustment

•Loosen the two screws locking the pan and tilt tables.

•Pan and tilt the table to aim the camera at what you need to watch.

•Turn the azimuth adjuster to obtain a level image.

•Tighten the two screws after adjustment.

Variable angles plus or minus 75° (max.)

Monitor output jack

Pan lock screw Panning table

Tilting lock screw

Azimuth adjuster

-13-