Pantech WV-NW474S Gain Control Setting AGC ON DNR-L, DNR-H/OFF, Shutter Speed Setting SHUTTER

3.Move the cursor to the area where backlight is bright and press [SET] to mask that area. The mask turns to white. (When the cursor is moved on an area that has already been masked, the mask and cursor start blinking.)

Blinking

4.Repeat step 3 to mask the desired areas. To cancel masking, move the cursor to that area and press [SET].

5.After masking is completed, press [SET] for 2 sec- onds or more. The ALC CONT menu appears.

6.If you want to change the video output level (picture contrast), move the "I" cursor for LEVEL and adjust the level.

Turns to white

Blinking

Note: If ON is selected for SUPER-D2, a shadow (black line) may appear at the boundary between the bright and the dim scene. This is a natural phenom- enon and does not indicate trouble.

4.Gain Control Setting (AGC ON (DNR-L, DNR-H)/OFF)

You can set the gain (brightness level portion of an image) to automatic level adjustment.

Move the cursor to AGC and select automatic level adjustment ON (DNR-H), ON (DNR-L) or fixed level (OFF).

ON (DNR-L):Selects lower noise reduction level.

ON (DNR-H):Selects higher noise reduction level.

OFF (Fixed Level): Disables the gain control func- tion.

The factory default setting is ON (DNR-H).

Notes:

•If ON (DNR-H) is selected for the AGC, the noise reduction function is automatically activated under low light conditions to reduce noise. In pictures containing a moving object, this may result in an afterimage.

•DNR-L is recommended for pictures containing a moving object that results in an afterimage. However, the noise slightly increases.

•DNR-H and DNR-L do not appear for AGC on the system controller setup menu.

5.Electronic Sensitivity Enhancement (SENS UP)

There are two modes for SENS UP.

AUTO: If you select X10 AUTO, for example, the sensitivity is automatically raised to X10 max. When AUTO is selected, AGC is automatically set to ON.

FIX: If you select X32 FIX, for example, the sensitivi- ty is raised to just X32.

The factory default setting is OFF.

Move the cursor to SENS UP and select the parameter for electronic sensitivity enhancement.

3. Shutter Speed Setting (SHUTTER)

Note: To select electronic shutter speed, select OFF for SUPER-D2 in the ALC CONT menu.

Move the cursor to SHUTTER and select the electronic shutter speed.

The preset values for SHUTTER (electronic shutter speed) change by pressing [Light] or [Right] as follows: The factory default setting is ---.

OFF 1/100 1/250 1/500

1/10000 1/4000 1/2000 1/1000

-30-

The preset values for SENS UP (electronic sensitivity enhancement) change by pressing [Light] or [Right] as shown at right:

OFF X2 AUTO X4 AUTO X6 AUTO X10 AUTO OFF

X32 FIX X16 FIX X10 FIX X6 FIX X4 FIX X2 FIX

Notes:

•When ON is selected for SUPER-D2 in the ALC CONT menu, FIX is not available for this item.

•When you select AUTO for SENS UP and ON for SUPER-D2, the SENS UP function has priority so that the SUPER-D2 function is not activated auto- matically.

•While the SENS UP function is selected, noise, spots or a whitish phenomenon may appear in the picture when the sensitivity of the camera is increased. This is a normal phenomenon.