Pantech WV-NW474S Alarm Setup, E-mailNotice, Attach Image, Destination E-mailAddress, Alarm Type

■Alarm Setup

1.Open the Alarm Setup window.

2.External Alarm

•Select ON or OFF for External Terminal Input, and click the [SET] button.

ON: Receives alarm inputs via the ALARM IN termi- nal.

OFF: Ignores alarm inputs via the ALARM IN termi- nal.

Note: See SPECIFICATIONS for alarm input condi- tions.

3.E-mail Notice Setup

Note: Sending E-mails will not be possible in an environment where POP (Post Office Protocol) authentication is required.

E-mail Notice:

ON: Sends an E-mail when an alarm arises.

OFF: Does not send.

The default setting is OFF.

E-mail Server Address (IP Address/Host Name): Input the IP address or host name of the mail server. The host name can be input in up to 128 characters. When using DNS, input a text line with "host name. domain name".

-37-

Sender E-mail Address: Input the administrator’s address. The default setting is NW-camera.

Attach Image:

ON: Attaches the alarmed picture to the E-mail.

OFF: Does not attach. The default setting is OFF.

•Click the [SET & REBOOT] button.

Destination E-mail Address:

•Input a maximum of four addresses and click the [SET & REBOOT] button.

Delete Destination E-mail Address:

•Select an unwanted address and click the [DEL] button.

4.Recording Setup

Number of recorded images (frames) before: 0 - 20

after: 1 - 20

Image Recording Rate (fps)

before: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5.

after: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5, 10.

The default setting is 1 for both before and after.

•Click the [SET & REBOOT] button.

5.Panasonic Protocol Setup

Panasonic Protocol

ON: Applies the Panasonic Protocol.

OFF: Does not apply.

Destination Port

Input a destination port number. The port number is exclusively assigned to this function, and any other usage is not allowed.

Number of Retries

Available Times: 1-25

•Click the [SET] button.

Destination IP Address

•Input a maximum of eight IP address for Panasonic Protocol destination and click the [SET] button.

Delete Destination IP Address

•Select an unwanted IP address and click the [DEL] button.

6.External Terminal Alarm Output Setup

Alarm output is supplied from the Alarm OUT con- nector when the Alarm input terminal or VMD is acti- vated.

Alarm Type

Pulse: Holds active status during the specified time width.

Latch: Holds active status until it is reset manu- ally.

Pulse Width

•Select a number from 1-100 if you selected Pulse.

The pulse width will be the selected number x 100 ms.