•A mail can be sent to a maximum of four addresses, with or without attached picture file.
A mail contains: the camera name, time & date of occurrence, cause of event, and the reference addresses to the stored pictures as follows.
The number of stored alarm pictures: e.g., 472
URL of the picture: http//(Camera IP address)/ ALMxxxx_00.jpg
Notes:
•“xxxx” stands for the event number, and “00” for the picture number.
•A picture numbered “00” will be automatically attached to the mail.
•Enter “39” instead of “00” in the address bar if you wish to view #40 picture.
•There may be cases where you cannot access the images notified by the mail when new alarm activa- tions took place after having sent the mail.
•The alarm picture number is updated during record- ing.
•Alarm pictures and recording log are deleted when the power is turned off.
•The Alarm List number is updated as alarm pictures are to the set number.
■Transferring Picture Files
•You need to set the Alarm FTP Transmission to ON in the FTP Client menu.
•Pre- and
•A picture file attached to a mail can be sent to the specified mail addresses.
Note: When many alarm events arise at the same time, it may happen occasionally that a mail is sent with- out an alarm picture attached.
■Canceling Alarm Display
“Alarm” display in the upper center will disappear when you do the following.
•Click the [Go to Main Menu] button after once the
Alarm List.
Or
•Click the [Go to Main Menu] button after opening any of the setup menus.
■VMD Setup
You can set up VMD (Video Motion Detector).
●Detection Area Setup
1.On the Setup Menu tab, click the [Camera] button. The menu control buttons appear under the image display area.
2.Click the [MENU ON] button.
**SET UP ** will be overlaid on the camera picture.