![](/images/new-backgrounds/1190971/1909715x1.webp)
Important Information
Important Safety Instructions
1.Read and follow all warning notices and instructions marked on the product or included in the manual.
2.Do not allow anything to rest on the power cord and do not locate the product where persons will walk on the power cord.
3.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous high voltage points or other risks. Refer all servicing to qualified service personnel.
4.General purpose cables are provided with this product. Special cables, which may be required by the regulatory inspection authority for the installation site, are the responsibility of the customer.
5.When installed in the final configuration, the product must comply with the applicable Safety Standards and regulatory requirements of the country in which it is installed. If necessary, consult with the appropriate regulatory agencies and inspection authorities to ensure compliance.
6.A rare phenomenon can create a voltage potential between the earth grounds of two or more buildings. If products installed in separate buildings are interconnected, the voltage potential may cause a hazardous condition. Consult a qualified electrical consultant to determine whether or not this phenomenon exists and, if necessary, implement corrective action prior to interconnecting the products.
7.In addition, if the equipment is to be used with telecommunications circuits, take the following precautions:
ÐNever install telephone wiring during a lightning storm.
ÐNever install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
ÐNever touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
ÐUse caution when installing or modifying telephone lines.
ÐAvoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
ÐDo not use the telephone to report a gas leak in the vicinity of the leak.
October 1997 | B |