Paradyne 7924 manual Displaying Line Build-Out Definitions, Switchpack Settings for Line Build OUT

Customizing DSX-1-Compatible Units

Displaying Line Build-Out Definitions

Enter 7 at the Config prompt to display the switchpack and board settings for line build-out. Use this information to change the line build-out parameter manually. (Switchpack definitions are also listed in Appendix C, Switchpacks and Jumpers.)

Config→ 7

*****SWITCHPACK SETTINGS FOR LINE BUILD OUT *******

Switchpack Settings

±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±

Position #4 ± Bit 0		OFF=0, ON=1
Position #5 ± Bit	1	OFF=0, ON=1
Position #6 ± Bit	2	OFF=0, ON=1

************ Switchpack Definitions ************

Bit 2 Bit 1 Bit 0 Application

±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±

0	0	0	0 to 133 feet ± 0dB
0	0	1	133	to 266 feet
0	1	0	266	to 399 feet
0	1	1	399	to 533 feet
1	0	0	533	to 655 feet
1	0	1	-7.5 dB
1	1	0	-15 dB
1	1	1	-22.5 dB

Config→

For example, to change the line build-out to 399 to 533 feet, while in Switchpack Mode, set position 6 OFF and positions 4 and 5 ON.

NOTE:

The switch combinations for ±7.5, ±15, and ±22.5 dB line build-out are not for use with this product. Use of these settings will cause a weak signal and degrade performance.

4-6 October 1997 7924-A2-GB20-30