Switchpacks and Jumpers, DSX-1-Compatible Units | Paradyne 7924

Switchpacks and Jumpers

C

DSX-1-Compatible Units

Use Figure C-1to assist you in locating the switchpacks and jumpers on the board.

The jumper and switchpack detailed in Figure C-1are used to change configuration options. All other jumpers (listed below) must remain as positioned at the factory.

Jumper

Pins (Factory-Setting)

P1

P3

P8

P9

P10

P11

P12

2±3

No Jumper

2±3

2±3

1±2

1±2

1±2

7924-A2-GB20-30

October 1997

C-1

Image 51

Paradyne 7924 manual Switchpacks and Jumpers, DSX-1-Compatible Units, Jumper Pins Factory-Setting

Contents

Model 7924 Standalone T1 Hdsl Termination Unit Warranty, Sales, and Service Information Copyright 1997 Paradyne Corporation All rights reservedTrademarks Important Safety Instructions EMI Warnings Contents Customizing V.35-Compatible Units Iii Cable Pin Assignments About This Guide Document Purpose and Intended AudienceDocument Summary Document Number Document Title Product-Related Documents HotWire 7924-A1 Models and Features About HotWire Model Termination Units Model Number Features Campus Network Applications Typical Configurations DCS User Interface Types Cellular Network Access Installing the Unit Package Checklist for HotWire Model 7924-A1Overview DSX-1-Compatible HotWire 7924 ± Rear Panel Connecting to the NetworkConnecting Power to the Unit Procedure Using Terminal and Switchpack Modes Choosing an Interface ModeConnecting to a System Terminal Switching Between Terminal and Switchpack Modes Customizing DSX-1-Compatible Units Accessing Configuration Options Making Changes from the Terminal Interface Hdsl Card Type DSX-1-Compatible Units Configuration Options 1 DSX-1-Compatible Units Configuration Options 2 Displaying Switchpack Definitions Making Changes in Switchpack Mode Displaying Line Build-Out Definitions Switchpack Settings for Line Build OUT Customizing V.35-Compatible Units Customizing V.35-Compatible Units ± 6 x 64 384 kbps ± No change to rate V.35-Compatible Units Configuration Options Making Changes in Switchpack Mode CO/CP OFF=CP, ON=CO What to Monitor Monitoring the Unit Board Status Board Status for DSX-1-Compatible UnitBoard Status for V.35-Compatible Unit Performance Statistics Performance Statistics for V.35-Compatible Unit Performance Statistics for DSX-1-Compatible Unit Remote Unit Information Front Panel LEDs DSX-1-Compatible UnitMeaning Compatible Unit Testing Detecting a ProblemUnderstanding Loopback Tests Local Loopback, Initiated at the CO Unit Local Loopbacks Remote Loopback, Initiated at the CO Unit Remote Loopbacks Starting and Stopping Loopbacks Resetting the Unit Worksheets DSX-1-to-DSX-1 Configuration LAN DSX-1-to-V.35 Configuration Unframed Operation Time Slot DS0 AssignmentsPayload Rate DSX-1 T1 DS0s Used Compatible Units Configuration Worksheet DSX-1-Compatible Units Configuration Worksheet Terminal Connection Cable Pin Assignments Cable Pin Assignments Pin Hdsl Loop Connection Cable Pin Assignments T1 Network Connection Cable Pin Assignments Connection Cable Pin Assignments Direction Code Pin NameFunction Description Switchpacks and Jumpers Jumper Pins Factory-SettingDSX-1-Compatible Units Switchpacks and Jumpers Compatible Units Jumper P8 COM port Factory defaultsGlossary GL-1 Reset GL-2Loopback IN-1 Index Index IN-2