Patton electronic SL4020 manual Connect to the Internet service provider

SmartLink 4020 Getting Started Guide 2 • SmartLink installation

Note The SmartLink has automatic MDX (auto-crossover) detection and configu- ration on all Ethernet ports. Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.

5Connect to the Internet service provider.

The external router power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).

Verify that the proper voltage is present before plugging the CAUTION power cord into the receptacle. Failure to do so could result in

equipment damage.

6Verify that the AC power cord included with your router is compatible with local standards. If it is not, refer to “Contacting Patton for assistance” on page 83 to find out how to replace it with a compatible power cord. Plug the power adapter into the 12V DC, 1.0A port on the SmartLink 4020. Connect the other end of the power cord to an appropriate AC power outlet.

7Wait 30 seconds after powering the SmartLink 4020 on, then verify that the green Power LED is lit (see figure 3). At this point, you should be able to use your browser to surf the Internet.

Note Follow the directions of your voice service provider to set up voice services.

Figure 3. Router front panel LEDs

Installing the router 24