Patton electronic SL4020 manual Sample Dial Plans, Simple Dial Plan, Non-dialed Line Dial Plan

SmartLink 4020 Getting Started Guide C • Dial plans

Introduction

The H.323 and SIP code will allow provisioning (via web browser) of the dial plan. A dial plan gives the unit a map to determine when a complete number has been entered and should be passed to the gatekeeper for reso- lution into an IP address. Dial plans are expressed using the same syntax as used by MGCP NCS specification.

The formal syntax of the dial plan is described by the following notation:

Digit ::= "0" "1" "2" "3" "4" "5" "6" "7" "8" "9"

Timer ::= "T" "t"

Letter ::= Digit Timer "#" "*" "A" "a" "B" "b" "C" "c" "D" "d"

Range ::= "X" "x" -- matches any digit

"[" Letters "]" -- matches any of the specified letters Letters::= Subrange Subrange Letters

Subrange::= Letter -- matches the specified letter

Digit "-" Digit -- matches any digit between first and last Position::= Letter Range

StringElement::= Position -- matches any occurrence of the position

Position "." -- matches an arbitrary number of occurrences including 0

String ::= StringElement StringElement String StringList::= String String "" StringList DialPlan::= String "(" StringList ")"

A dial plan, according to this syntax, is defined either by a (case insensitive) string or by a list of strings. Regard- less of the above syntax a timer is only allowed if it appears in the last position in a string (12T3 is not valid). Each string is an alternate numbering scheme. The unit will process the dial plan by comparing the current dial string against the dial plan, if the result is underqualified (partial matches at least one entry) then it will do nothing further. If the result matches or is over-qualified (no further digits could possibly produce a match) then send the string to the gatekeeper and clear the dial string. The Timer T is activated when it is all that is required to produce a match. The period of timer T is 4 seconds. For example a dial plan of (xxxTxxxxx) will match immediately if 5 digits are entered, it will also match after a 4 second pause when 3 digits are entered.

Sample Dial Plans

Simple Dial Plan

Allows dialing of 7-digit numbers (e.g. 5551234) or an operator on 0. Dial plan is (0Txxxxxxx)

Non-dialed Line Dial Plan

As soon as handset is lifted the unit contacts the gatekeeper (used for systems where DTMF detection is done in-call). Dial plan is (x.) i.e. match against 0 (or more) digits. Note: the dot ‘.’

Complex Dial Plan

•Local operator on 0, long distance operator on 00

•4-digit local extension number starting with 3, 4, or 5

•7-digit local numbers are prefixed by an 8

Introduction 92